Improved calibration on Nittan panels
Initialising calibration on a Nittan panel no longer causes rate of rise heat detectors to enter fire condition.
Hochiki remote LED operation
When using remote indicators on a Hochiki protocol panel, the LEDs now operate without needing to be programmed within cause and effect output groups.
Accurate CO life safety event reporting
On a mixed networked system of MxPro 5 Gen 1 and Gen 2 panels, events and text now show correctly in the log. If viewing a Gen 2 panel log from a Gen 1 panel across the network, AdvancedLive no longer shows ‘Not Connected’ faults as CO life safety events, and CO life safety events […]
Apollo Discovery multisensors with heat point enabled no longer report fault
When using Apollo protocol MxPro 5 panels with Discovery multisensors and the heat point enabled, the panel no longer reports a ‘Too Low’ fault against the heat point sub-address. The panel now retrieves the correct analogue value from enabled heat points so that the correct device state is reported.