Menu

Category: MxPro

How to install key switches

Optional key switches (volt-free) are available to be mounted on the MxPro 5 panel fascia plate. These are pre-wired with the appropriate 2-pin connector. To install a key switch, follow these easy steps: Use a sharp knife to cut through the fascia label using the aperture profile as a template. Insert the key-switch mechanism and […]

Save time and cost with multiprotocol networks

MxPro 5 panels can be used with Apollo, Hochiki, Argus Vega and Nittan (Evo) protocols. Each Advanced panel must be connected to only one type of protocol from the four available. However, you can easily use panels supporting different protocols to build 'multiprotocol' networks across sites. This is a significant advantage when replacing panels in […]

MxPro 5 powerful cause-and-effect programming

The MxPro 5 product range offers a vast array of powerful 'cause and effect' programming options. A standard mapping version is available for less demanding projects, while the demands of more challenging sites are easily met by using flexible logic and programming options. The MxPro 5 product range can accommodate up to 200 network panels […]

Converting MxPro 4 to MxPro 5

Replacing an old MxPro 4 for a newer MxPro 5 panel is as easy as 1,2,3. This process eliminates the need to reprogram the config from scratch, saving you valuable time. To convert the panel, follow the three steps below: 1. Open your saved copy of the MxPro4 config. 2. Click on Product Details and […]

MxPro 5 - programmable time clocks

The MxPro 5 product range includes ten onboard programmable time clocks that can be used independently, or as part of a site-wide cause & effect strategy to control the operation of output modules across an entire network system. Time clocks are most commonly used for class change, output control, detector mode change, investigation delays and […]